REF 451105
Transfer paper
Transfer waterslide paper.
50x70cm - 170gsm
Directions of use:
The drawing is made with lithographic crayons or with tusche diluted by solvents (no water-based material because it will disolve the gum layer on the paper.)
Place a finely grained stone (or plate) on the press bed and adjust the pressure for normal printing less something like 1/2 turn.
Dampen equally the entire surface of the stone.
Place the transfer paper on the stone, a backing sheet, the tympan and run it through the press.
Add 1/4 turn pressure and run it through the press again.Wet the back of the transfer paper, add 1/4 turn pressure and run it through the press twice.
Re-wet the back of the paper and run it through the press two times (or more if there is any doubt).
Generously wet the back of the transfer paper, wait a couple of minutes and gently peel off the backing of the transfer paper.
Let the drawing sit overnight.
Talc and etch the stone.
Good luck!
Customers who bought this product also bought:
A3 laser film matt-translucent